Water Heater Pilot Light Doesn T Stay On

Pilot light issues are some of the most common problems experienced with gas water heaters.

Water heater pilot light doesn t stay on.

A pilot light is a small device that is designed to provide the flame and light the gas coming out of the gas valve and main burner. If your pilot doesn t re light won t stay lit or keeps going out after a short time you most likely have an issue with the hot water heater thermocouple. If your gas water heater doesn t stay lit you may have a defective control thermostat. After taking the necessary precautions clean the pilot tube with a small needle.

When the water heater pilot light goes out first try relighting it following the directions on the water heater label. If the pilot doesn t relight if it goes out right after lighting or if it goes out repeatedly by far the most common cause is. Cold and helpless in anthem ariz says the pilot light on his atwood 6 gallon water heater stays on only when the button is depressed on the control valv. When you re done test the heater on and see if the pilot light stays lit.

The water heater pilot light is a small flame that ignites the gas burner on your water heater. Without it the water heater won t be able to maintain internal temperatures allowing the water to cool off. Make sure to follow the directions on your water heater label. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature.

If it doesn t remove the tube and clean it again. However all subsequent ignition attempts fail. There are other tanks that have light sensors flame sensors and someone if that s yours th. Later in the day when the thermostat kicks in it doesn t work.

It has a hot surface ignitor rather than a pilot light. If i turn the unit on the burner will light and fully heat the water tank. This can happen with age. Water heater pilot light keeps going out.

The pilot light in your hot water heater does more than simply ignite the gas. The gas supply to the pilot assembly is controlled by this valve. It is common on fireplaces and older cheaper furnaces and water heaters. A pilot light is always burning while using a small amount of gas either a water heater is running or not.

I have a ruud powervent water heater.