Water Softener Regeneration Steps

The majority of home water softeners are equipped with automatic regeneration devices.

Water softener regeneration steps.

To understand the water softener s regeneration process you first have to find out what are the different parts and how they work. Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed. The regeneration process starts with a backwash during which the softener pumps water backward through the treatment medium to remove sediment. The following steps are involved with regeneration.

Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank. The softener then goes back into what we call service position and the owner enjoys another 1 200 gallons plus or minus of soft water. This step takes about 10 minutes. Remove the lid and refill your water softener s salt hopper with softener salt then close.

Water softener regeneration is the process which the softener system removes the existence of calcium and magnesium as well as other minerals and dirt from the water. To improve efficiency and extend the life of your water systems scale causing calcium and magnesium ions are replaced with sodium ions in the softening process. The third and last step of the regeneration is to pass a high capacity flush of water through the mineral to ensure salt free water goes to the tap. You can set a water softener to regenerate at a specific time that best fits your family s schedule.

These devices work by either using a clock or by monitoring the amount of water used demand initiated regeneration softeners to tell the water softener when it is necessary to shut down and regenerate. Here are the typical water softener regeneration steps. Backwash brine draw slow rinse and fast rinse.